EasyManua.ls Logo

Warwick Corvette Standard - FNA Jazzman; Thumb Bass; Thumb Bolt-on

Warwick Corvette Standard
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Bridge
Bass
Tone Control
Mid
Tone Control
Treble
Tone Control
Push/Pull
Volume/Pickup Pan
Stacked Control
**
FNA Jazzman
All FNA Jazzman basses come either with an onboard active MEC 3-way circuit,
or Seymour Duncan
Basslines preamp (upto 2001 or optional).
Push/Pull Volume/Pickup Pan Control (Part #M89252 -2 x 220K, 500K)*
Treble Tone Control (Part #M85100 - 100K)
Mid Tone Control (Part #M85100 - 100K)
Bass Tone Control (Part #M85100 - 100K)
* By pulling on the volume knob, you will bypass the onboard preamp (MEC)
* By pulling on the volume knob you will activate the slap contour EQ curve on the Seymour Duncan Basslines preamp. This curve will boost the bass frequencies and the
high fre-quencies, while slightly cutting the mid frequencies. Pulling the knob does not deactivate the active preamp (Seymour Duncan Basslines).
**When the switch is in the up position the bridge pick-up is humbucking and routed in series. When the switch is in the middle position the bridge pick-up is
single coil and routed as humcanceling with the neck pick-up. When the switch is in the down position the bridge pick-up is humbucking and routed in parallel.
Bridge
Stacked Push/Pull
Volume/Pickup
Pan Control
Mid
Tone Control
Stacked Bass/Treble
Tone Control
Thumb Bass
All Thumb basses come with an onboard active preamp.
Stacked Pick-up Pan/Volume Control (Part #M88552 - 500K, 2 X 25K)*
Stacked Tone Control (Part #M85110 2 X 100K)**
Mid Tone Control (Part #M85100 100K)
* By pulling on the volume knob, you will bypass the onboard active preamp, which effectively deactivates the tone controls.
**The top knob boosts or cuts the treble and the bottom knob boosts or cuts the bass.
Bridge
Push/Pull
Volume Control
Pickup
Pan Control
Stacked Bass/Treble
Tone Control
Thumb Bolt-on
All Thumb Bolt-on basses come with an onboard active preamp.
Push/Pull Volume Control (Part #M84500 - 500K)*
Pick-up Pan Control (Part #M85252 25K)
Stacked Tone Control (Part #M85110 2 X 100K)**
* By pulling on the volume knob, you will bypass the onboard active preamp, which effectively deactivates the tone controls.
**The top knob boosts or cuts the treble and the bottom knob boosts or cuts the bass.

Related product manuals