Washtech CD100 - Operator Troubleshooting

2/9/2021 12
Operator Troubleshooting
Issue Cause
POOR PRE-SCRAPING CARRY OVER OF SOAP FROM SINK OVERLOADING RACKS POOR MACHINE CARE JETS BLOCKED OR ARMS OBSTRUCTED CURTAINS NOT FITTED CORRECTLY WATER SUPPLY PRESSURE LOW POOR WATER QUALITY** RINSE TEMPERATURE LOW <75Ĺ% PAWL DRIVE NOT OPERATING CRASHING SOUND AGAINST DOOR
DISHES NOT CLEAN
 
    
STAINING
 
  
FOAMING


PROTEIN BLOOM
     
DIRTY MACHINE
 
   
FOOD RESIDUE ON WARE
      
FILM/SPOTS ON WARE
     
DETERGENT RESIDUE
  
GREASY FILM/NO FIZZ
  
WET WASHWARE

 
SCALE BUILD UP IN MACHINE
 
FILTERS ON OTHER EQUIPMENT

LIMIT SWITCH ACTIVATED

WASH ARM NOT FITTED PROPERLY

MACHINE STOPS & REFILLS CONSTANTLY

 Likely cause
 Possible cause
* For issues most likely due to incorrect chemical dosages or other chemical issues, we
recommend you consult your chemical supplier and/or a local chemical expert prior to calling
in a dishwasher technician.
** For issues that are likely due to poor water quality (scale building up, filters being required
on other kitchen equipment etc.), we recommend you consult a local water specialist prior to
calling in a dishwasher technician.
IF PROBLEMS PERSIST CONTACT STARLINE SERVICE ON 0800 STARLINE
Washtech CD100 L Operator Manual