Wasp Barcode Technologies WPL308 Series - Product Features; Printer Standard Features

- 2 -
1.2 Product Features
1.2.1 Printer Standard Features
The printer offers the following standard features.
Product standard feature
200 dpi
model
300 dpi
model
600 dpi
model
Thermal transfer/ or direct thermal
○ ○ ○
LED icon panel with 1 button
○ ○ -
3.5” TFT LCD with 6 buttons
- - ○
32-bit RISC high performance processor
○ ○ ○
Gap transmissive sensor (Fixed, center of offset 4 to right or 7
mm to left from center)
○ ○ ○
Black mark reflective sensor (Position adjustable)
○ ○ ○
See-through ribbon end sensor
- - ○
Ribbon encoder sensor
For single printing, the label length should be more than 3 mm.
39.4mm is the threshold of ribbon low detection. The ribbon LED becomes
blinking if ribbon supply roll diameter is less than 39.4 mm.
○ ○ ○
Head open sensor
○ ○ ○
128MB Flash memory
○ ○ ○
128 MB DDR2 DRAM
○ ○ ○
Micro SD card reader for memory expansion, up to SDHC 32GB
○ ○ ○
RS-232 interface (Max. 115,200 bps)
○ ○ ○
USB 2.0 interface (Hi-speed mode)
○ ○ ○
Internal Ethernet print server (10/100 Mbps) interface
- - ○
USB host
○ ○ ○
Real time clock & Buzzer
- - ○
Standard industry emulations right out of the box including
Eltron
®
and Zebra
®
lan
g
ua
g
e su
pp
ort
○ ○ ○
Internal 8 alpha-numeric bitmap fonts
○ ○ ○
Fonts and bar codes can be printed in any one of the four
directions (0, 90,180, 270 degree)
○ ○ ○
Internal Monotype Imaging
®
true type font engine with one CG
Triumvirate Bold Condensed scalable font
○ ○ ○
Downloadable fonts from PC to printer memory
○ ○ ○
Clean print head warning
○ ○ ○