Why is the chlorine level low in my Waterco Water Filtration System pool?
A low chlorine level may occur if the operating time is too short, so try increasing it. The production control might be set too low; in this case, set the production higher. Also, check the salt level and add the required amount if it's low. Finally, incorrect pool chemistry can be a factor, so have your water tested.
What to do if my Waterco Water Filtration System unit does not operate?
If the unit isn't operating, first check if there is electrical power. Ensure the Hydrochlor® switch is on, connect the power, and check the fuse.
How to fix a Waterco Water Filtration System that is not keeping time?
If your system isn't keeping time, reset the clock and connect the battery link. If the battery is flat, it will require a reset after a blackout. If this doesn't solve the problem, it may be due to an electrical fault, and you should return it to the distributor for repair.
The Power Pack monitors and controls chlorine production by regulating electrical energy supplied to the salt cell.
Programme the chlorinator timer to turn on or off at any time that suits your lifestyle.
Explains the ability to reverse polarity to clean calcium build-up off electrodes.
Guidelines for positioning the cell and ensuring a gas trap is provided.
Provides a step-by-step guide for cleaning calcium build-up from the salt cell plates.
Lists common symptoms, possible causes, and recommended remedies for issues.
Outlines essential safety precautions for installation, operation, and maintenance.
General| Brand | Waterco |
|---|---|
| Model | HYDROCHLOR 30 SC |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
