Storage and maintenance:
- Replace the lter regularly according to the light of the lter life indicator.
- Do not store the lter for a long time, and place it in a dry, cool place when not in use.
- The water source needs to meet the requirements of municipal tap water.
Manufacturer Technical Support
Tel: 1-888-352-3558 (U.S.)
E-mail: service@waterdroplter.com
Made in China V001
Qingdao Ecopure Filter Co., Ltd.
Warning:
To reduce the risk of property damage due to water leakage, this lter MUST be installed in accordance with the manufacturer’s
specications and instructions. Failure to follow instructions and operating specications will void your warranty. Further,
manufacturer assumes no responsibility or liability for damages arising out of misuse of the product.
Frequently asked questions:
Q: After lter replacement and ushing, the dispenser displays L1 to prompt a water change.
Can I continue to use it without changing the water?
A: After the MRO lter is replaced, the dispenser will be automatically ushed for 5 minutes. The
concentrated water produced by ushing will return to the feed water tank, leading to increase of
impurities in feed water. To protect the lter life and keep the freshness of the drinking water, it is
recommended to use it after changing the water in the feed water tank.
Q. Why does the ltered water taste bad?
A: The rst 3L/102 OZ of water cannot be drunk! After that, it is recommended to ush the whole
ltration dispenser (from water tank to water dispensing) for another 12L/4080 OZ of water, and you
will get the best taste!
If the dispenser has not been used for a while, follow the emptying mode prompt to ush.
If the lter is not replaced in time, please replace the lter immediately.
Q: Why is the lter life indicator still red after the lter is replaced?
A: You have forgotten or failed to reset the ” ” key. Please reset it again: Hold the “ ” key for 5
seconds for lter reset.
To Next Page
Loading...
