1
Inspect the Package
Open the box and take out the system housing, all the components and connection fittings. Inspect
them according to the parts list to ensure nothing is left out or damaged during shipping. If there are any
parts cracked or broken, please do not proceed with the installation and contact our customer sevice
+1-888-352-3558 (U.S.) or send an email to service@waterdropfilter.com to identify and get familiar with
all components for quick installation.
Before Installation
Installation Instructions
WD-K6/WD-KJ600
6.7”
*
17.5”
*
16.6”
1,600 gallons
600 GPD
14.5-87 psi/0.1-0.6 MPa
5-38 °C / 41-100 °F
Municipal Tap Water
40-95 °C/104-203 °F
220-240V / 6.25A
50 HZ
Specifications
To achieve the optimal performance, it is highly recommended to use the system within the operational
parameters.
WARNING: A 220-240 volt, 50 Hz, AC only 13 or 16 ampere fused, grounded electrical supply is
required. It is recommended that a separate circuit serving only your hot water dispenser be provided.
NOTE:
• The maximum daily capacity is tested under 25˚C water temperature, and 34.8±2.9 psi feed water
pressure.
• If you are using well water as the source, please ensure that the feed water has been through a
pre-filtration system.
• Do not use it with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after using of the system.
Required Tools
• Variable speed drill • Screwdriver
• Utility knife or scissors • Flashlight
• Drill bit: 1/4" (for drainpipe), 1" (for faucet hole) • Towel
• Adjustable wrench, pliers
Model
Size (L*W*H)
Feed Water Pressure
Feed Water Temperature
Feed Water Requirement
Hot Water Temperature
Rated Voltage/Current
Rated Frequency
Rated Capacity
Maximum Daily Capacity
To Next Page
Loading...