Waterdrop WD-TSB-10 User Manual

Figure 3
Figure 1
Figure 4
Figure 2
Step 2: Connect the water supply (cold water only)
1. Shut o the water supply and remove the faucet hose.
2. Connect the feed water adapter and ensure that the rubber O-ring is loaded.
• If the angle valve outlet is 3/8”, connect it to the water supply and faucet hose directly. (Figure 3)
• If the angle valve outlet is 1/2”, you need to remove the above two ttings before connection. (Figure 4)
3. Connect one end of the 1/4" PE tubing to the inlet of the lter head. Until you reach the mark on the
tubing.
Triple Stage Undersink Water Filtration System
WD-TSB-10 system | Installation Instructions
Filter head
Stainless faucet
Quick-connect fitting
Mark for full insert
3/8”-1/2” converter
3/8”-1/2” converter
Feed water adapter
Teflon tape
1/4” tubing
3/8" Cold water valve 1/2" Cold water valve
Note: The service life mentioned above is subject to chlorine reduction. Actual result varies according
to the local water quality.
Precautions
• Do not use it with water that’s microbiologically unsafe or of unknown quality without adequate disinfection.
• For use only with cold water.
• Do not freeze the lter, as this can cause cracking and water leakage.
• Do not allow children under 3 years old to have access to small parts during installation of this product.
• This installation must comply with all applicable state and local regulations.
• Turn o the water supply while replacing the lter.
Operating temperature
Working pressure
Flow rate
Filter capacity
2-38℃/35-100℉
10-125psi (0.7-8.6bar)
1gpm
Specifications
Feed water requirement Municipal tap water
WD-10PP: up to 6 months
WD-10GC: up to 8-12 months
WD-10CT: up to 12-18 months
WARNING
Please read it carefully before installation.
Installation of the filter system
Tips: How to use the quick-connect?
To connect: There is an existing mark at the end of the tubing for you to conrm if the tubing is fully
inserted into the tting. (Figure 1)
To disconnect: Use your thumb and index nger to press down on the lock sleeve. Use your other hand to
pull out the hose from the tting. (Figure 2)
Note: Please do not pull out the tubing directly, or else it will damage the tting and cause leakage.
Step 1: Fix the filter head and the filter
1. Paste the assistant label to nish drilling.
Note: Mount the water lter at least 2 inches higher
than the ground for easier lter change.
2. Install the screw and reserve enough space to hang the lter.
3. Hang the lter system on the screw.
Press
Pull
Press

Waterdrop WD-TSB-10 Specifications

General

Installation	Under Sink
Certifications	NSF/ANSI 372 certified
Filter Media	Carbon block filter
Reduction Claims	Reduces chlorine, taste and odor
Dimensions (Filter Housing)	4.7" diameter x 15.7" height
Included Components	Faucet

Summary

Filter System Installation Guide

Quick-Connect Fitting Usage

Instructions on how to connect and disconnect tubing using quick-connect fittings.

Install Filter Head and Filter

Steps to mount the filter head and hang the filter system on a screw.

Connect Water Supply

Guide to connect the filter system to the cold water supply line.

Faucet Installation and Leak Checks

Install the Faucet

Instructions for installing the system's faucet onto the countertop or sink.

Flush Filter and Check for Leaks

Procedure to flush the filter and identify and fix any water leakage.

Filter Replacement and FAQs

Filter Replacement Procedure

Steps for safely removing and installing new filter cartridges.

Handling Water Leaks

Troubleshooting steps if water leakage occurs after installation.

TDS Value Explanation

Clarification on why the filter may not lower TDS values.

Filter Lifespan and Replacement

Guidance on when to replace the filter based on usage and water quality.

Substances Reduced by Filter

Information on contaminants, like chlorine and heavy metals, the filter reduces.

System Model Difference

Distinction between WD-TSA and WD-TSB system models.

Warranty and Support

1-Year Quality Assurance

Details on the limited warranty for mechanical parts and filter cartridges.

Customer Service Contact

Contact information for customer support and website live chat.