Waterite Fusion 2 - User Manual

By Waterite, Inc.
Advanced Water Conditioners
Addendum for the F2TC Time Clock Valve
OWNER’S MANUAL ADDENDUM
FOR ALL FUSION² F SERIES AND FCA SERIES WATER CONDITIONERS
EQUIPPED WITH THE F2TC TIME CLOCK VALVE
THIS MANUAL IS TO BE LEFT WITH THE OWNER OF THE EQUIPMENT FOR
REFERENCE PURPOSES AND TECHNICAL GUIDANCE. IT IS STRONGLY
RECOMMENDED THAT QUALIFIED DEALER SERVICE PERSONNEL BE
CONTACTED IN THE EVENT OF AN UNKNOWN INTERRUPTION OF SERVICE OR
APPARENT PRODUCT MALFUNCTION. AN ANNUAL PREVENTATIVE
MAINTENANCE INSPECTION BY A WATER PROFESSIONAL IS RECOMMENDED
TO ENSURE TROUBLE-FREE AND CONTINUOUS OPERATION.
www.waterite.com
Waterite, Inc. ■ Winnipeg, MB Canada
R2

Summary

How to Use This Addendum

For The Dealer

Instructions for dealers before installation and system setup.

For The Installer

Instructions for installers on setup, settings, and startup.

Quick Reference Information

General Operation

Explains system displays and toggling between time of day and days until regeneration.

To Set Time of Day

Steps to reset the time of day after a power outage.

To Set Time of Regeneration

Procedure to adjust the regeneration time setting.

Manual Regeneration

How to initiate immediate or tonight's regeneration cycle.

Error Codes

Information on error codes displayed on the unit.

General Instructions

System Setup

Guide to configuring the control valve through system setup steps.

Installer Settings

Procedures for installer settings, including regeneration time and days.

Installer Settings

Regeneration Time & Days Between (1-99 day option)

Sets regeneration time and number of days between regenerations (1-99).

Regeneration Time & Days Between (1-7 day option)

Sets regeneration time and day of the week for regeneration (1-7).

Setting the Time of Day

Normal Operating Displays

Describes the two displays showing time of day or days until regeneration.

Regeneration Mode

Explains the system's regeneration process and display changes.

Manual Regeneration

Detailed steps for initiating manual regeneration immediately or tonight.

Power Loss & Error Messages

How power outages affect time and error code indications.

Start Up Instructions

For All Units

General startup steps for all units, including initial fill and backwash.

For Softeners and Regenerating Filters Only (Programs PO-P6)

Specific startup steps for softeners/filters including draw and refill cycles.

For Backwashing Filters and Acid Neutralizers (Programs P7-P9)

Startup steps for filters/neutralizers including final rinse.

Troubleshooting Procedures, Timeclock Units

Timer does not display time of day

Causes and solutions for the timer not displaying time of day.

Timer does not display correct time of day

Causes and solutions for incorrect time display on the timer.

Unit regenerates at wrong time of day

Causes and solutions for regeneration occurring at the wrong time.

E1, E2 or E3 Error Codes displayed

Explains error codes E1, E2, E3 and recommended actions.

Valve stalled in regeneration

Identifies causes and solutions for the valve stalling during regeneration.

Unit does not regenerate automatically when UP and DOWN buttons are pressed

Troubleshoots issues with manual regeneration initiation.

Unit does not regenerate automatically but does when UP and DOWN are depressed

Diagnoses why automatic regeneration fails but manual works.

Waterite Fusion 2 Specifications

General

Brand	Waterite
Model	Fusion 2
Category	Water System
Language	English