terminals:
The blue wire must be connected to the
terminal marked N (Neutral) LOAD or
coloured black. The brown wire must
be connected to the terminal marked L
(Live) LOAD or coloured red.
The green/yellow coloured wire must
be connected to the terminal marked E
(Earth) or coloured green.
Warning: This appliance must
be earthed.
The fused spur must be accessible after
installation.
If the supply cord is damaged, obtain
a special cord from the Customer Care
Helpline, which must be tted by a quali-
ed person.
Troubleshooting
Before you call Customer Care, please
check the following points:
Burner fails to ignite:
• Check the electricity supply is on.
• Check the fuse.
There is a spark to the burner
but it fails to ignite:
• Check that the ame holes in the
ame spreader are clear of water or
deposits.
• Check that the gas supply is turned
on.
Smell of gas:
• Check that none of the controls have
inadvertently been turned on. If all
the controls are in the off position,
turn off the gas supply & call Cus-
tomer Care.
The burner ame appears
uneven:
• Check the burner is tted correctly.
• Check the ame holes in the ame
spreader are clear of water or de-
posits.
To Next Page
Loading...