EasyManua.ls Logo

Waterline essentials ESSGH60E - Using the Hob

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Do not let pans overhang the control
knobs, as this may overheat and
damage them.
Never leave fat or oil unattended on
a lit hob.
CAUTION: Where this appli-
ance is installed in a boat or
caravan, it shall not be used as a
space heater.
Check that all controls are in the
off position when you have n-
ished cooking.
Ignition
Auto ignition (if tted):
Push in and hold down the control knob,
and turn to the full on position (large
ame symbol). Keep the knob depressed
after the burner has lit for up to 15 sec-
onds to allow the ame to establish. Turn
the control knob to the desired setting.
Manual ignition (if tted):
Push in & hold down the control knob
turning to the full on position (large
ame symbol) & press the ignition but-
ton until the gas lights. Keep the control
knob depressed after the burner has lit
for up to 15 seconds to allow the ame
to establish. Turn the control knob to the
desired setting.
In the event of the burner ames being
accidentally extinguished, turn off the
burner control and do not attempt to re-
ignite the burner for at least 1 minute.
Reduced rate
Turn the control knob to the small
ame symbol.
To switch off
To switch off a hob burner, turn the con-
trol knob clockwise to the “off” position.
If the ignition fails
1. Make sure all the controls are in
the “off” position, and check there
is a spark at the back of the burner
when you depress the control knob
or press the ignition button.
2. Gas check - check there is gas to the
appliance by lighting a burner with a
lighted match.
3. Electrical check-if no spark renew
the 3 ampfuse in the fused spur.
4. Check burner caps are tted cor-
rectly.
Using the hob
Adjust the burner ame so that it does
not extend over the pan base.
Pans
Use pans with a at base of mini-
mum 120mm / 4 ins diameter and
maximum 250mm / 10 ins diameter
which are stable in use.
Do not use double pans, rim based
pans, old misshapen pans or any
pan which is unstable when placed
on a at surface.
Position pans over the centre of
the burners, resting on the pan