Do you have a question about the Watermill BP100D and is the answer not in the manual?
Ensure no foreign particles enter pump outlets to prevent malfunction and damage.
Avoid connecting to water mains pressure and check boiler compatibility.
Do not fit non-return valves in the inlet line; pump must vent to the supply tank.
Prevent solder flux contact with plastic parts, especially push-fit rings.
Purge pump with water for 5 mins before running; check for leaks.
Place pump close to water source, low down, with high input head for best performance.
Pump MUST be earthed; consult electrician if unsure.
Connect Brown to L, Yellow/Green to E, Blue to N, ensuring secure connections.
Purge system thoroughly with water before switching on electrical supply; check for leaks.
Check supply, fuses, valves, filters, pump orientation, and water flow.
Check hot water outlet flow, stopped flow, entrapped air, or jammed flow switch.
| Brand | Watermill |
|---|---|
| Model | BP100D |
| Category | Water Pump |
| Language | English |