Need help?Do you have a question about the Watermill BP65S and is the answer not in the manual?
General| Power source | Electric |
|---|---|
| Maximum suction height | 8 m |
| Pump housing material | Plastic |
| Frequency | 50 Hz |
| Material | Plastic |
| Maximum flow rate | 6500 l/h |
| Max Flow Rate | 6500 l/h |
| Inlet/Outlet Size | 1 inch |
Do not connect the pump to water mains pressure; it cannot normally be used with combination boilers.
Do not let the pump run dry. Purge with water for 5 minutes before running and check for leaks.
Do not use any jointing compounds for hot water cylinder connections.
Avoid direct mains connection, use 22mm pipe, and position tank connector correctly.
Use supplied hoses, ensure hose depth, use isolation valves, and align pipework correctly.
This pump must be earthed. Electrical hazard will result if not correctly earthed.
Do not run pump dry. Purge water, check for leaks, and inspect connections.
Do not remove the pump from installation, as this will invalidate the guarantee.
To Next Page
