EasyManua.ls Logo

Waterpik Water Flosser WP-260 User Manual

Waterpik Water Flosser WP-260
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
QUICK START GUIDE
Model WP-260
1
Prepare the Reservoir:
Remove the reservoir from
base and fill with lukewarm
water.
Replace the reservoir onto the
base, PRESSING DOWN FIRMLY
to ensure full seating.
Fill
Replace
When tip is properly
inserted there should be
no gap between handle
and colored tip ring.
2
Select and Insert Tip:
4
Prior to Very First Use of Unit, Prime
Unit:
Set pressure control dial on base to
high, point the handle and tip into sink.
Turn unit ON until water flows from the
tip. Turn unit OFF.
3
Prime Unit (First Time Use Only):
Adjust Pressure Control:
For first time users, adjust pressure
control to lowest position. Gradually
increase pressure to your liking.
Press tip
firmly into
handle.
Low
I
1
2
3
O
High
I
1
2
3
O
NO
Gap
1
2
3
I
O
Insert
1
2
3
O
This device is compatible with global voltages of 100 - 240VAC, 60/50Hz.
continued on back
Question and Answer IconNeed help?

Do you have a question about the Waterpik Water Flosser WP-260 and is the answer not in the manual?

Waterpik Water Flosser WP-260 Specifications

General IconGeneral
Model NumberWP-260
CategoryPersonal Care Products
Pressure Settings3
ColorWhite
Warranty3 years
Reservoir Capacity22 oz
Pulsations Per Minute1200
Power SourceElectric
Included Tips2
Water Tank Capacity22 oz
Pulse Rate1200 pulses per minute

Summary

Waterflosser Reservoir and Tip Preparation

Fill and Replace Reservoir

Remove reservoir, fill with lukewarm water, and replace firmly to ensure full seating.

Select and Insert Tip

Press tip firmly into handle until no gap is visible between handle and colored tip ring.

Initial Waterflosser Setup and Pressure Adjustment

Prime Unit for First Use

Set pressure control dial to high, point handle into sink, turn ON until water flows, then OFF.

Adjust Pressure Control

For first-time users, set to lowest position and gradually increase pressure to liking.

Water Flosser Usage and Tip Removal

Mouth Placement and Water Stream

Place tip in mouth before ON, lean over sink, aim stream at 90 degrees above gumline.

Flossing Technique

Start with back teeth, follow gumline, pause between teeth for thorough cleaning.

Remove Water Flosser Tip

Slide tip eject button up on handle to remove tip. Do not use while running.

Product Registration and Support

Register Product Online

Register online at www.waterpik.com/registration for savings on additional products.

Related product manuals