What to do if the WaterRower S1 monitor is not turning on?
If the monitor is not turning on, check the batteries positioned behind the monitor. Unscrew the monitor and gently lift it to access the battery pack.
What to do if the WaterRower Fitness Equipment monitor is flashing zeros?
If the monitor is flashing zeros, it may be because the disk shifted during shipment. Try raising the sensor disk located on top of the clutch. Also, if the bolts on the upper deck and forward riser were not uniformly tightened during assembly, the alignment may be off. Loosen and retighten these bolts.
Why are the bolts on my WaterRower Fitness Equipment loosening?
Bolts can loosen over time with use. Gently tighten the bolts using the 5mm Allen key. If they continue to loosen, use a small amount of medium strength Loctite[®] to fasten them more securely.
What to do if my WaterRower S1 paddle is not turning smoothly?
If the paddle isn't turning smoothly, loosen all the tank bolts and then retighten them.
What to do if WaterRower S1 monitor is not counting down?
If the monitor is not counting down, check that the monitor and sensor connector are connected and that all wiring is intact.
Lists all main and other parts needed for assembly.
Details strokerate, heart rate, duration, intensity, and distance displays.
Instructions for setting up a distance-based workout.
Details the duration and terms of the product warranty.
Explains the process for claiming warranty service.
Outlines customer duties for warranty claims.
Describes WaterRower's actions in handling warranty claims.
Lists conditions that invalidate the warranty.
Limits liability for consequential or incidental damages.
General| Type | Rowing Machine |
|---|---|
| Resistance Type | Water |
| Weight Capacity | 1000 lbs |
| Monitor | S4 Performance Monitor |
| Weight | 117 lbs |
| Storage | Upright |
To Next Page
