Need help?Do you have a question about the Watersnake Saltwater ASP T-18 and is the answer not in the manual?
General| Thrust | 18 lbs |
|---|---|
| Shaft Length | 24 in |
| Voltage | 12V |
| Weight | 2.2 kg |
| Control Type | Tiller |
| Mount Type | Transom |
| Warranty | 2 Years |
| Type | Electric |
| Speeds | 5 forward, 2 reverse |
| Battery Requirement | 12V Deep Cycle |
Ensure the nut is fitted firmly inside the pocket underneath the base.
Place base, mark pilot holes, drill, and attach bracket with provided hardware.
Place metal column on base and screw bolt to hold parts in place temporarily.
Assemble both swivel clamps and other parts as shown in diagram 1.
Attach the jack beam using the screws provided.
Assemble the depth adjustment clamp and the steer handle.
Slide jack beam into swivel clamp and tighten all screws and bolts.
Details forward/reverse (I o R) and low/high speed (=) switches.
The handle is stowable and extends with a button pull for compact storage.
Place shear pin, align propeller, and tighten propeller nut securely.
Connect red cable to positive (+) and black cable to negative (-) terminals.
Recommended to protect motor circuit boards; attaches to red power cable.
Required for normal operation; withstands repeated cycles, delivers sustained power.
Table provides suggested wire gauge based on extension length (1m, 3m, 5m).
Rinse with fresh water, wash with soapy water to remove salt/debris.
Lubricate friction points, check screws, terminals, and fuse/circuit breaker.
Ensure motor is mounted correctly and not run out of water for long periods.
Disconnect motor before charging; store motor under cover, away from elements.
Check battery, connections, fuse, propeller obstruction, and shear pin.
Check propeller tightness, shear pin, debris, and battery charge.
Check obstructions in bracket and lubricate shaft.
Kits include propeller, nut, shear pins; accessory kit has wrench and pins.
Extends handle length for better control and reach.
To Next Page
