www.watersnake.com.au
9
DEPTH ADJUSTMENT
Hold the motor shaft with one hand, loosen the depth collar adjustment screw
and set the motor to the desired depth. Then retighten the adjusting screw on
the depth collar securely.
STOWING
When your Watersnake motor is not in use always stow and store it properly.
DEEP CYCLE BATTERIES
A 12v deep cycle marine battery is required for normal operation and continued
use of your Watersnake motor. 12v deep cycle marine batteries are constructed
using thicker plates and a denser active material. They are built to withstand
repeated charge and recharge cycles. Deep cycle marine batteries are
specifi cally designed to deliver sustained power with low current draw over
extended periods of time. Car / Truck / Motorcyle batteries are not designed
in the same way and are more useful for providing high bursts of power for
short periods. Use of car / truck / motorcycle batteries can cause damage to
electronic components within your Watersnake motor.
BATTERY CHARGING
• Do not attempt to charge your battery while your Watersnake is still
connected to the battery.
• Do not connect your Watersnake motor to a battery that is connected to your
main motor’s charging system (alternator).
• It’s important to note that a fully charged 12v deep cycle battery will actually
provide more than 12v (refer to your battery supplier for more information)
and at 12v or less your Watersnake motor may not operate normally.
• Do not connect your Watersnake motor directly to solar panels.
VENOM SX
Note that above table is intended as a guide only. Your local electrical supplier will
be able to advise in greater detail based on your particular set up and requirements.
WIRE EXTENSION LENGTH SUGGESTED WIRE GAUGE
1m 6 AWG / 6GA
3m 4 AWG / 4GA
5m 2 AWG / 2GA
To Next Page
Loading...
