WaterSoft DS32P - General Specifications; Softener Specifications

WARNING
Lubricants
Do NOT use Vaseline, oils, hydrocarbon lubricants or spray silicone anywhere! Petroleum base lubricants will
cause swelling of o-rings and seals. The use of other lubricants may attack plastic Noryl®. It is recommended that
Dow Corning® silicone grease be used as a lubricant for all control valves. Dow Corning® 7 Release Compound
is used in the manufacture of Chandler Systems control valves. (Part # LT-150)
Sealants
Pipe dope and liquid thread sealers may contain a carrier that attacks some plastic materials. It is recommended
that Teflon® tape be used to seal plastic Noryl® threaded fittings.
Softener Specifications
3
General
Specications
AS24P
AS24VP
DS24P
DS24VP
AS32P
AS32VP
DS32P
DS32VP
AS48P
AS48VP
DS48P
DS48VP
AS64P
AS64VP
DS64P
DS64VP
Grains Capacity / lbs.
Salt Per Regeneration
24K / 12
19K / 6
32K / 15
30K / 12
22K / 6
48K / 23
44K / 18
33K / 9
63K / 30
59K / 24
44K / 12
Grains Capacity / lbs. Salt Per Generation
with Vortech
24K / 7.5 32K / 9 48K / 15 64K / 18
Maximum Raw Water Hardness (grains) 50 75 100 100
Maximum Clear Iron/Manganese (ppm) 3 5 5 5
Cation Exchange resin (cu. ft.) 0.75 1 1.5 2
Mineral Tank (polyglass) 8 x 44 9 x 48 10 x 54 12 x 52
Brine Tank (polyethylene w/ grid) 18 x 33 18 x 33 18 x 33 18 x 33
Service Flow Rate (gpm) 7 8 10 12
Backwash Flow Rate (gpm) / Vortech 1.5 / 1.2 2.0 / 1.5 2.4 / 2.0 3.5 / 2.4
Space Required (D x W x H) in inches 18 x 26 x 51 18 x 27 x 55 18 x 28 x 61 18 x 30 x 59
Approximate Shipping Weight 88 lbs. 100 lbs. 133 lbs. 164 lbs.