Waterstone 5000 - Troubleshooting; Product Features

VEN-038-HTTK
PROBLEM: Water and steam is spitting from the Filtration Faucet spout
WHAT TO DO: The unit is boiling. Turn on the faucet’s hot water and
release the water. Adjust the water temperature on the display to a
lower setting.
PROBLEM: Water is not hot.
WHAT TO DO: Turn on the power and press the ON/OFF/SET button.
Adjust the water temperature or pre-set on the display to a higher
setting. Press the ON/OFF/SET button again and conrm the heat up.
PROBLEM: The electronic display has not been powered up
WHAT TO DO: Check that the unit is plugged in and power is on.
PROBLEM: Water is too hot.
WHAT TO DO: Water temperature is set too high. Adjust the water
temperature on the display to a lower setting.
PROBLEM: Water is dripping from the Filtration Faucet spout.
WHAT TO DO: The expansion chamber isn’t draining the system
correctly due to dispensing very small amounts of water. Dispense 2
cups of water to clear and prime the system. Avoid dispensing less than
1/2 cup of water per use.
PROBLEM: The spout is blocked
WHAT TO DO: Remove and clean the aerator. Bleed system to remove
any air. Prime tank to allow correct operation.
PROBLEM: Slow ow from the spout
WHAT TO DO: Water lter may be clogged from impurities in the water.
Water lter must be changed every 6 months to maintain warranty.
PROBLEM: Water does not ow right away.
The Hot Tank is designed for non-pressurized operation. There will be
a slight delay until the near boiling water appears. If a large volume
of water has been dispensed on the previous use, there may a slightly
longer delay in the water appearing from spout.
PROBLEM: No water owing
WHAT TO DO: Water valves may have been turned o or inlet hoses
may have been twisted or blocked. Turn on all the water valves and
ensure the hoses are not twisted or kinked to restrict ow. The Hot Tank
is not under pressure, so there will be a slight delay in water ow after
the hot water faucet handle has been turned on. This is normal and
indicates that the Hot Tank is functioning properly.
TROUBLESHOOTING
PRODUCT FEATURES
• Compatible with RO ltration systems.
• Digital temperature control 167F to 208F (75C to 98C).
• Six temperature presets: 167F, 176F, 194F, 203F, 206F, and 208F.
• Electronic control display panel.
• Insulated 1 ⁄ 2 gallon stainless steel tank.
• Maximum inlet pressure regulated for protection.
• Dry burn and over heat protection sensors.
• Heating element: 1500 watts, 120 volts.
• Non-pressurized bladder system.
• 1/4” NPTF inlet and outlet connections.
• Protective metal casing.
• Dimensions: 7-7/8”L x 8-7/8”W x 12-1/4”H.
• Works with any Waterstone Hot Only or Hot & Cold Filtration Faucet.
• Manufactured by Aqualogic.
• 3 year Waterstone warranty.
PERFECT FOR INSTANT HOT COFFEE, TEA, SOUP AND COOKING
41180 Raintree Court • Murrieta, CA 92562
1-888-304-0660 • 951-304-0520
www.waterstoneco.com