Waterstone 5000 - Before You Begin Your Installation

1 2 3 4
Turn o water supply. Observe all local
plumbing codes.
Inspect waste and water
supplies for signs of damage.
Replace as necessary.
DO NOT use petroleum
based products on this
faucet.
REQUIRED TOOLS: PARTS INCLUDED:
1. Adjustable Wrench 2. Tape Measure
INLET CONNECTOR 1/4”
NPTF TO 1/4” TUBE
OUTLET CONNECTOR 1/4”
NPTF TO 5/16” TUBE
BEFORE YOU BEGIN YOUR INSTALLATION:
3 LINE VENTED FAUCET
Connection to a non-vented faucet WILL DAMAGE THE TANK and void the warranty. A kinked tank
outlet tube or debris in the faucet obstructing the free ow of water from the tank will subject the tank
to pressures exceeding its design limits and cause the tank to leak. The Hot Tank is an open vented system
appliance. When not being operated, the pressure is 0psi. Minimum operating pressure is 22psi.
WARNING - USE OF AN IN-LINE INSTALLATION OF A WATER CHILLER WITH A WATERSTONE FAUCET OF
ANY KIND WILL VOID OUR WARRANTY.
Since 2005, Waterstone has continued to advise all of our customers against the installation of any brand of
in-line water chiller unit with our faucets. Compressor style chiller units have been proven to arbitrarily exceed
the standard household in line pressure ratings causing the faucet inlet connection line to burst and create the
potential for water damage claims in the eld.
Waterstone can not and will not be held liable for damages created by a use for which our products were not designed. Waterstone will only
recommend the installation of a water chiller in the vented side (in place of a hot tank) with one of our Hot or Hot & Cold Filtration faucet models.
INSTALLATION GUIDE
WARNING!
THE WATERSTONE #5000 HOT TANK IS DESIGNED FOR USE WITH
A 3 LINE VENTED FAUCET ONLY.