FLUSHING THE HOT TANK
It is recommended that you ush through the system 2 or 3 times to ensure the system is fully operational. Turn on hot water until hot water
within the tank has emptied. Allow the unit to reheat and then repeat.
WATER DRAW BACK AND CONTAMINATION IN THE TANK
You must ensure that the faucet spout is not submerged in water, especially during the dispensing of hot water when the hot water handle is
closed. This will cause water draw back and contaminate the tank.
POWER SAVING
If the unit is not being used for long periods of time, turn o the unit to save power.
SEASONAL SHUTDOWN
Both the Hot Tank and Filtration Faucet must NOT be exposed to freezing temperatures. If there is a possibility of this, the system must be
drained of water. Shut-o the main water supply and unplug the unit from the power socket. Allow the tank to cool for at least 1 hour.
Disconnect the blue inlet and clear outlet tubes from the connectors on the tank. Lift the unit to the sink, turn upside down and drain all the
water from the tank. When re-installing, follow the original installation instructions.
NOTICE
Like any water heater, the Waterstone Hot Tank has a limited operational life span. In order to ensure maximum performance, the unit should
be ushed and inspected regularly for any water leakage or damage. This will help avoid possible property damage or personal injury. If a leak
is found, replace any connectors and loose or split tubes. Place the unit in a drain pan or use a Waterstone AS-414 Safety Valve-Leak Detector
for added leak protection.
This product can cause harm if installed incorrectly. Carefully read these instructions before installing and operating the Hot Tank. Failure to
comply with these instructions could result in property damage, serious injury or death.
• Make sure all electrical wiring and water connections conform to local codes. Standard 120v electrical outlet is required under the sink. If
possible, use a separate circuit dedicated to your Hot Tank.
• To avoid shock, serious injury or death, use a grounded power connection. DO NOT place cord, plugs or unit near or in water or other liquids.
• DO NOT disassemble main box or any part of the power supply.
• DO NOT operate the Hot Tank controls or power supply with wet hands.
• Check the power rating of your Hot Tank. Make sure it is suitable for the power rating of the electrical circuit it is being installed on.
• DO NOT operate or install the unit if it appears to have any missing parts or damaged in any way.
• DO NOT use outdoors or in a damp area or in a location that may fall below 32F.
• DO NOT use for anything other than intended domestic use. Not intended for commercial use.
• The Hot Tank must be installed vertically with inlet and outlet connections at the top of unit.
• Ensure the front of the unit is visible and the front control panel can be easily reached.
• DO NOT attempt to open, modify or service this electronic Hot Tank unit. Opening the unit will void the guarantee.
• Due to high water temperature, and for safety reasons, the Hot Tank unit is not under pressure. It is an open vented system unit.
• Turn o all controls before unplugging.
• To avoid the risk of ooding and property damage, regularly inspect the connections for any signs of leakage.
• DO NOT connect to a standard faucet. May cause injury, will damage the Hot Tank and void the guarantee.
• Keep children away from unit.
• DO NOT directly wash unit with water.
• Under sink should be ventilated and protected from direct sunshine.
• Humidity should stay in a range of 10% to 60%. Be sure there is no dew.
SAFETY INSTRUCTIONS
MAINTENANCE AND CARE INSTRUCTIONS
To Next Page
Loading...