Waterway pro clean plus - Filter System with One-Piece Base Assembly; Base and Pump Mounting; Filter and Inlet Connection

3
ASSEMBLY INSTRUCTIONS
FOR FILTER SYSTEM WITH ONE-PIECE BASE
1. Put the base on level ground. Place pump on base. 2. Attach pump to base with included screw.
3. Place filter inside base. Wrap 3 or 4 turns of Teflon tape on 2" tailpiece
and thread into “inlet” in filter. DO NOT insert snap pins through
(secure) motor base until Step 3 is complete.
Teflon taped
2" tailpiece
threaded
into “inlet”