To Next PageTo Next Page
Need help?Do you have a question about the Waterway SMF-115 and is the answer not in the manual?
General| Model | SMF-115 |
|---|---|
| Category | Water Pump |
| Horsepower | 1.5 HP |
| Max Head | 115 ft |
| Speed | 3450 RPM |
| Discharge | 1.5 inches |
| Outlet Size | 1.5 inches |
| Phase | Single Phase |
Warning about following all notices and instructions for installation to prevent severe injury, death, or property damage.
Manual contains important installation, operation, and safe use info for the owner/operator.
When pump is within 5 ft. of pool walls, use No. 8 AWG or larger conductor for bonding.
Warning to reduce injury risk by supervising children closely when using the product.
Caution against installing in an outer enclosure or beneath a hot tub/spa skirt unless marked.
Warning of electrical shock/electrocution risk; installation by licensed electrician per codes.
Note on closing lines before opening pot and re-opening valves before operating when installed below water level.
Warning not to open strainer pot if pump fails to prime or runs dry, to avoid vapor pressure and scalding.
Caution to clean pump strainer and skimmer baskets regularly for proper operation and to prevent damage.
Warning about high pressure and potential for lid blow-off causing severe injury if system is serviced improperly.
Note against wrapping motor in plastic for storage to prevent condensation and rust.
Instructions for protecting the motor from heat, including shading and ventilation.
Instructions for protecting the motor from foreign matter, splashing water, and dust.
Instructions for protecting the motor from splashing pool water, weather, and lawn sprinklers.
Caution to avoid scratching polished seal faces to prevent leaks.
Caution that polished and lapped seal faces can be damaged if not handled with care.
Caution not to run the pump dry as it will damage the mechanical seal and cause leaks.
Remedies for pump not priming, including checking suction piping, lid seal, and water level.
Remedies for pump not priming due to insufficient water, checking lines, valves, and water level.
Diagnosing and fixing reduced flow due to air pockets, leaks, clogged impeller, or clogged strainer.
