Watson-Marlow 630 Du - Page 2

11.2 Wiring the US NEMA module 20
11.3 Earth screening of control cables on NEMAmodule 20
12 Start-up check list 21
13 Control wiring 22
13.1 Upper D-connector 22
13.2 Lower D Connector 22
13.3 Standard - 25 way D: Inputs and Outputs 23
13.4 Standard - 25 way D: power supply limits 31
13.5 N - Modules Standard and SCADA 31
13.6 Standard N - Module 31
13.7 SCADA N-Module 35
13.8 Standard - 9 way D - RS232 Use 39
14 Switching the pump on for the first time 44
14.1 Selecting the display language 44
14.2 First-time start-up defaults 46
15 Switching the pump on in subsequent power cycles 48
16 Mode menu 49
17 Manual 50
17.1 START 50
17.2 STOP 51
17.3 INCREASING AND DECREASING FLOW RATE 51
17.4 MAX FUNCTION (Manual mode only) 52
18 Flow calibration 53
18.1 Setting the flow calibration 53
19 Analog mode 56
19.1 Analog calibration 57
19.2 Calibrate Input 1 58
19.3 Setting a high signal 59
19.4 Setting high flow calibration 60
19.5 Setting a low signal 61
19.6 Setting low flow calibration 62
19.7 Calibrating the scaling input 64
19.8 Setting a high signal 66
2 m-630dun-en-08.2