U.S. Patent: 7,277,012
Santa Clara, CA 95050
DT-300
v3
Occupancy Sensor
Voltage .......................... 18-28VDC/VAC, half wave rectified AC
Current Consumption ........................................................25 mA
Power Supply ..................................... WattStopper Power Packs
Isolated Relay Rating ........................................ 1A @30VDC/VAC
Operating Temperature .......................32° to 131°F (0° to 55°C)
Light Level One-Step Adjustment .........................10FC—300FC
Time Delay Adjustment ...................... 30 seconds to 30 minutes
Walk-Through Mode .....3 minutes if no activity after 30 sec
Test Mode ................................ 5 sec. upon DIP switch reset
PIR Coverage (Typical) .....................................................1300 ft
2
Sensitivity Adjustment ....... High or Low (DIP switch setting)
Ultrasonic Coverage (Typical) ..........................................1300 ft
2
Sensitivity Adjustment .........................Min. to Max. (trimpot)
Frequency......................................................................40kHz
UL & CUL Listed for use with WattStopper Power Packs
To Next Page
Need help?
General
