Innovation Water Heaters – Edge [i] Controller
Venting and Combustion Air Design Guide
TAG-0090_A • GF-5056 • 2/20/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 20 of 39
Figure 8: Vent Installation onto Water Heater – Innovation Shown
WARNING
DO NOT INSULATE OR OTHERWISE WRAP VENT PIPE OR FITTINGS.
Sections 3.2 and 3.3, below, discuss specific installation regulations for side-wall and vertical
terminations, respectively.
STRAIGHT VENT STARTER PIPE
MINIMUM 24” (61 cm)
1/4" CAP SCREW [4X] (6.4 mm)
1/4" FLAT WASHER [4X] (6.4 mm)
CLEAN BOTH
SURFACES,
THEN APPLY
HIGH TEMP
SILICON
SEALANT HERE
To Next Page
Loading...
