Wavetek IS-136 MS - User Manual

Questions and Answers

C
Crystal HobbsAug 11, 2025
What to do if Wavetek Test Equipment MEASURE mode shows no results?
- C
  craig30Aug 11, 2025
  If the Wavetek Test Equipment in MEASURE mode displays no results, there could be a couple of reasons. First, ensure a signal is present at the connector indicated in the DEF.SET menu (RF or RF-DIR). Second, the signal source might be on a different frequency than expected. Verify the mobile station's actual TX frequency using the Spectrum ANALYZER and adjust the channel number and Channel 0 TX Frequency accordingly.
N
Nancy AustinAug 21, 2025
Why Wavetek IS-136 MS Test Equipment CALL mode MS does not register?
- B
  bruce65Aug 22, 2025
  If the MS does not register with the STABILOCK 4032 in CALL mode, consider the following: 1. The frequency might be incorrect; determine the channels used by the system for which the MS is programmed and enter the channel 0 frequency in the DEF.SET mask. 2. The setup might be for the wrong connector; check if the signal is applied to the same connector as indicated in the DEF.SET menu (RF or RF-DIR; the RF-DIR socket provides 20 dB higher input/output level). 3. The MCC (mobile country code) and/or MNC (mobile network code) might be wrong; select MCC according to the country in which the MS is used. A list of MCC’s is provided in the appendix of this manual.
M
Mitchell BlackwellAug 31, 2025
How to troubleshoot Wavetek Test Equipment MEASURE mode when result fields indicate "-----" only?
- R
  Ryan MccormickAug 31, 2025
  If the result fields in MEASURE mode of your Wavetek Test Equipment display "-----", it could be due to these reasons: * The signal might be unmodulated or using a modulation format other than TETRA. * The RF power might be too low. Ensure you're applying at least –15 dBm or 0.03 mW to the RF connector. You can verify the mobile station’s power level using the Spectrum ANALYZER.