Need help?Do you have a question about the Wavtech link2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Input Impedance | 20k ohms |
| Output Impedance | 50 ohms |
| THD+N | <0.01% |
| Signal to Noise Ratio | >110 dB |
| Current Draw | 150 mA |
| Category | Media Converter |
| Model | link2 |
| Manufacturer | Wavtech |
| Frequency Response | 10 Hz - 100 kHz |
| Outputs | RCA |
| Power Supply | 12V DC |
This red LED indicates when the link2 is powered on.
Jumpers control DC-offset and audio signal detection for automatic turn-on.
Connections for +12V battery, chassis ground, and remote in/out wires.
Connects speaker wires (high level) from the source to the unit.
Yellow LED indicates output signal level before distortion.
Matches output signal level to source and amplifier input capability.
Line level signal connections to your amplifier(s).
Pre-attached tabs for securing the unit during installation.
Connects the GND terminal to a metal part of the vehicle body.
Connects to the vehicle's +12V battery or power source with fuse.
Connects speaker wires from the source unit to the interface.
Connects to a switched +12V or remote trigger wire, or uses auto turn-on.
Provides a +12V trigger for amplifiers or other aftermarket devices.
Selectable per channel (20V/40V) for input sensitivity range.
Defeatable per channel (LOAD) to disconnect internal loading.
Product warranty information for domestic and international customers.
Contact details for Wāvtech Customer Service for product service.
To Next Page