Panel Control Keys
1) Power LED indicator and remote receiving window.
2) SOURCE: Press this key to enter the menu of signal source and choose signal source.
3) CH+/CH-: Press these two keys to select the channel. In OSD menu, press the two keys to adjust the items,
which have the same functions as ▲/▼ key on the remote control.
4) VOL+/VOL-: Press these two keys to add or reduce volume. In OSD menu, press the two keys to adjust the
analog value of selected item, which have the same functions as t/u key on the remote control.
5) MENU: Press this key to enter the main menu.
6)
7) Power switch(optional): Press '' I '' to turn power on, and press ''O'' to turn power off.
Note: Different models may have different appearances; please refer to the actual device.
Standby: To switch the TV on or back to standby.
8
Installing battery
Remove the battery cover, and insert two AAA (1.5V) batteries; make sure that the polarity of the battery is
consistent with the marks "+/-" in the battery slot.
Operating Notes for Remote Control
1. Aim the remote control at the remote receiving sensor. Any article placed between the remote control and
remote receiving sensor could affect the normal operation.
2. Do not shake the remote control or operate or put it under direct sunlight, as heat could deform the
remote control.
3. If the remote receiving sensor is located under direct sunlight or strong light, the remote control could fail to
work. Please change the light angle or TV angle or get closer to the remote receiving sensor to operate the
remote control.
4. Low battery power could affect the remote control distance, please replace the battery. If the remote control
is going to be idle for a long perid of time or the battery is used up, remove the battery to avoid any leakage,
eroding or damage to the remote control.
5. Do not use any batteries with any of other specifications. Do not mix the old and new batteries. Always
replace both batteries together.
6. Do not charge, disassemble, heat or burn the used battery as this may cause it into short circuit. Please
comply with the relevant environmental protection regulations to dispose of the waste battery.
Remote Control
7
2
3
4
5
6
1
To Next Page
Loading...
Need help?
General