EasyManuals Logo

WBOX Technologies 0E-RCKMT2200 User Manual

Default Icon
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
3
COPYRIGHT © 2019 ADI
4. Plug the UPS into a 2 pole, 3 wire grounded receptacle (wall outlet). Make sure the wall branch outlet
is protected by a fuse or circuit breaker and does not service equipment with large electrical
demands (e.g. air conditioner, copier, etc). The warranty prohibits the use of extension cords, outlet
strips, and surge strips.
5. Press the power switch to turn the UPS on. The Power-On indicator light will illuminate. If an
overload is detected, an audible alarm will sound and the UPS will emit one long beep. In order to
reset it, turn the unit off and unplug some equipment from outlets. Make sure the total load of the
equipment connected to the UPS is within the unit’s safe range, (refer to the technical specifications),
and then turn the unit on.
6. To maintain an optimal battery charge, leave the UPS plugged into an AC outlet at all times.
7. Before storing the UPS for an extended period of time, turn the unit OFF. Then cover it and store it
with the batteries fully charged. Recharge the batteries every three months or so, to ensure good
battery capacity and long battery life; further, this might also prevent damage to the unit from an
unlikely battery leakage.
8. The unit provides one Serial port and one USB port to allow connection and communication
between the unit and any attached computers. The Serial Port as well as its paired USB port allow for
bi-directional communication among the UPS and the primary connected computer running the
Power Management Software. The computer can monitor the UPS and alter its various
programmable parameters. When there is a power failure, the computer connected to the port will
start to shut down after a user controlled delay based on the settings given to the Power
Management Software.
Note: If the USB port is used, the serial port will be disabled. They cannot be used simultaneously.
Note: The Power Management Software is available on our website. Please refer to the address on
the included software download card for the free download.
9. EPO (Emergency Power Off) Port:
Follow the appropriate circuit diagram below to wire the cable to your EPO configuration. The EPO
remote switch is a switch installed in an outside area, connected to the unit via an ordinary RJ-11
phone line. In case of an emergency, it can be used to immediately cut-off power from the UPS unit.
INSTALLING YOUR UPS SYSTEM (continued)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WBOX Technologies 0E-RCKMT2200 and is the answer not in the manual?

WBOX Technologies 0E-RCKMT2200 Specifications

General IconGeneral
BrandWBOX Technologies
Model0E-RCKMT2200
CategoryUPS
LanguageEnglish

Related product manuals