Step 5: Adjusting to Your Phone Width
Loosen Knob A and fully open the phone holder.
Place your phone into the Holder and adjust it to
fit the width of your phone.
Step 4: Mounting WindshieldFone
Clean the windshield surface where you intend to
adhere the suction cup, then let dry completely.
We recommend using rubbing alcohol to clean
both the windshield and the suction cup.
Firmly press the Suction Cup against the
windshield.
While maintaining pressure on the base of the
mount, press the lever toward the windshield until
it snaps securely into place.
Ensure the Lever on the Base is in the release
position and that Knobs C and D are facing up.
Tighten Knob A.
© 2022 MacNeil IP LLC
I
M
J
N
K L
67WF1
To Next Page
Loading...
