Weaver W-957-40 - Default Chapter; Table of Contents

2
CONTENT
1.Preface-------------------------------------------------------------------------------------------------------4
WARNING CLAUSE -----------------------------------------------------------------------------------------------4
INTRODUCTION---------------------------------------------------------------------------------------------------4
INSTALLATION-----------------------------------------------------------------------------------------------------5
SAFETY REGULATION-----------------------------------------------------------------------------------------6
2. INSTALLATION & OPERATION------------- --------------------------------------------9
2.1INSTALLATION OF THE PROTECTIVE COVER------------------------------------------------------9
2.2INSTALLATION OF THE MAINSHAFT--------------------------------------------------------------------9
2.3EQUIPPING POWER SOURCE----------------------------------------------------------------------------9
3. TECHNICAL PERFORMANCE ---------------------------------------------------------10
3.1PERFORMANCE & CHARACTERISTICS-------------------------------------------------------------10
3.2MAIN TECHNICAL SPECIFICATION--------------------------------------------------------------------10
3.3WORKING PRINCIPLE--------------------------------------------------------------------------------------11
4. TRANSPORTATION & INSTALLATION-------------------------------------------11
4.1TRANSPORTATION------------------------------------------------------------------------------------------11
4.2INSTALLATION -----------------------------------------------------------------------------------------------12
5. SAFETY PRECAUTIONS -------------------------------------------------------------------12
6. CONFIGURATION & USE-------------------------------------------------------------------14
6.1 CONFIGURATION ------------------------------------------------------------------------------------------14
6.2 CONTROL PANEL-------------------------------------------------------------------------------------------15
6.3 BASIC OPERATION----------------------------------------------------------------------------------------16
6.4 VALUE INPUT------------------------------------------------------------------------------------------------17
6.5 RESIDUAL UNBALANCE VALUE DISPLAY-----------------------------------------------------------19
6.6 BALANCE MODE & ALU BALANCE MODE SELECT----------------------------------------------19
6.7 SUPPLEMENTARY EXPLANATION -------------------------------------------------------------------21
7. PROGRAM SETUP-------------------------------------------------------------------------------22