31
key to adjust the value in the right window to be the diameter of the rim. You
can also realize the conversion of the unit of the Dia to be mm by the key .
4. Lower down the protective cover（you can also press the start key）. After the machine start,
rotate and test, it will automatic stops. In the left /right window, the corresponding values will be
displayed. Rotate the tire, when all the position indication lamps light. Pls add the weight
corresponding to the value displayed in the window. Once again, start the machine to test. The
window will display the unbalance value. The balance process will be completed until reaching
the balance range you requied.
9.2 MACHINE PARAMETER SETUP
Press to enter program setup menu.
1.1 -p-(hood setup) press to confirm the entrance select to setup the on/off of
the function of the hood. Press to confirm.
1.2 –SP-(hood control function setup)，In the upper condition, press . The display will
display as the left figure.
Press to confirm the entrance.
Select to setup the on/off of the hood function. Press to confirm after confirmation.
To Next Page
Loading...