34
In the condition of DYN, press the pizeo sensor
9.3 CUSTOMER SELF-CALIBRATION
In the condition of IN -TES，select to enter CAL –CAL，means customer
self-calibration state. We use this when the machine has not been used for a long time or the
balancing is inaccurate.
Press to enter into the program.
This function can be used after inputting tire parameter.
*hold on pressing for 5seconds to enter this state.
Press to enter and the display will display ―ADD‖-―O‖
Press to span the machine.
The window will display―ADD‖-―100‖,then Use your hand to rotate the tire until all the right
side lamp light up. At this moment clip the weight of 100g at the 12 clock
position outside of the tire. Press to span the machine. Until the span is over, you
finish the self-calibration of the machine.
To Next Page
Loading...