22
Press program key to enter the program setup menu.
-p- (protective cover setup) and then press key to confirm the entrance. Select
to set the on/off of the protective cover function. Then press key to return to
the upper level.
SP（protective cover control function setup）Select to enter. And press
key to enter. The setup is same to the above.
APP(Balance unit setup) can setup 1Gr and 5Gr。The setup is same to the above.
BIP (beeper setup) can setup the on/off of the beeper. The setup is same to the above.
SET UP Press to enter the special function setup.
IN TES (sensor test) to test the photocell and STA/DYN sensor.
Next menu: Select to enter [CAL] –[CAL]. This function is used when the
machine has not been used for long time or the balancing is not accurate.
Self-calibration program setup: Press to enter into the program and then press
to Confirm and the display will display ADD -0. Press the start key to start the test. After
running, the display will display ADD -100, rotate the tire until all of the unbalance position
lamp light up. Clip a weight of 100g at the 12 clock position on the tire. Once again start the
machine to realize the self-calibration of the machine. Enter the shortcut method of the
self-calibration program and hold on pressing for 5seconds and enter ―ADD‖-―0‖.
The above operation step vector diagram is as follows：
To Next Page
Loading...