Weaver W-957-40 - Page 28

28
correctly, it will influence the accuracy of the machine. On this condition, you need to reinstall
the sealing ring and assemble the machine and adjust again.
Technical safety card for using grease in the wheel balancer
Mobilgrease XHP
103
NLGI degree
3
Type of thickener
Li-complex
Colour, appearance
Dark blue
Penetration on the processed item 25°, ASTM D 217,
mm/10
235
Dropping point, °C, ASTM D 2265
280
Viscosity oil base, ASTM D 445, cSt @ 40°C
100
Change of penetration consistency, ASMT D 1831
(established upon the rolling of the greases), mm/10
10
4 spheres test, impression diam., ASTM D 2266, mm
0.5
4 spheres test, welding load, ASTM D 2509, kg
315
Test Timken OK load, ASTM D 2509, lb
45
Stability of oxidization bomb method, ASTM D 942, pressure
drop at 100 hours, kPa
35
Corrosion prevention, ASTM D 1743
Passed
Emcor rust, IP 220, wash away with acid water
0
Rust protection, IP 220-mod, wash away with distilled water
0
Corrosion on copper, ASTM D 4048
1A
Resistance to water spray, ASTM D 4049, % spray
15
Wash away with water, ASMT D 1264, loss (weight%), @ 79°C
5
SCRAPPING
If the machine is to be scrapped, separate all electrical, electronic, plastic and ferrous
components and dispose of them separately, as provided for by local regulations in force.
ENVIRONMENT INFORMATION
If the machines have the crossed-out bin symbol on their data plate , the following
disposal procedure must be applied to.
This product may contain substances that can be hazardous to the environment and to human
health if it is not disposed of properly.
Electrical and electronic equipment must never be disposed of in the usual municipal waste
but must be separately collected for their proper treatment.
The crossed-out bin symbol , placed on the product and on this page, reminds the user that
the product must be disposed of properly at the end of its life.