40 Series
12
– Make electrical connections.
See chapter 5.
– Place glass panel assembly on top of top frame and
attach it to LH and RH connecting brackets with
2x2 bolts M6x30.
– Align glass panel assembly with top frame.
Max. deviation left-right and front/rear = 2 mm.
– Install 4 bolts (R) through nylon rings (S), glass
panel (T), isolation sleeves (U) and screw into
connecting brackets (V).
Note: apply Loctite 243 on threads.
– Tighten screws to 4 Nm.
– Slide rails through sliding mechanisms.
To Next Page