Webasto BBW 46 - User Manual

Ident-Nr. 770 202 3/9808
Webasto Thermosysteme GmbH
82131 Stockdorf'Kraillinger Str. 5'Telefon (089)8 57 94-0
Telefax (089) 8 57 94-448'Telex 5 23 647 webas d
Operating Instructions
BBW 46 / DBW 46
Maintenance and Safety Information
1. Within the scope of the German StVZO (Road Traffic Licensing Act) a "General
Design Certification" has been granted by the Federal Office for Motor Traffic for the
BBW 46 / DWB 46 water heater.
2. Installation of the heater must be performed in accordance with the Installation
Instructions and is to be entered in the certificate of registration. If available, the approval
certificate or the General Design Certification is to be kept in the vehicle.
3. The year of the initial operation must be durably marked on the heater's nameplate by
crossing out the non-applicable years.
4. Claims can only be asserted if the claimant can prove that the maintenance and
safety notes were adhered to.
8. The heater must be inspected by a qualified expert annually, preferably prior to the
heating season commencing.
9. In the case of severe smoke development for an extended period of time, unusual
combustion noises or fuel smell (gas), the heater must be placed out of operation by
removing the fuse and may only be re-started after it was inspected by Webasto-trained
personnel.
10. Only the fuel specified on the nameplate may be used.
11. The heater should not be exposed to temperatures greater than 85°C (storage
temperature). Exposure to such temperatures will cause permanent damage to the
electronics.
12. Checking the cooling water level is to be performed in accordance with the vehicle
manufacturer's instructions. The water in the heater's heating circuit must contain at
least 20% of a good quality antifreeze.
13. Webasto will not assume any liability if the installation instructions and the notes
contained therein are not observed. The same applies to improperly performed repairs or
those where others than genuine replacement parts have been used. In those cases, the
heater's General Design Certification and thus the General Operating Permit
(homologation) will be invalidated as a consequence.
5. Due to the danger of poisoning or asphyxiation the heater must not be operated
in enclosed spaces (e.g. garages or workshops) without adequate exhaust
extraction. This should be considered when pre-setting heater operating times or
using the Telestart remote control.
6. Due to the danger of explosion the heater must be switched off at filling stations
and tank farms.
7. At locations where combustible vapours or dust accumulation can form (e.g. in
the vicinity of fuel, coal, saw-dust and grain depots and so forth) the heater must
be switched off due to the danger of explosion.
Troubleshooting
In the event of a malfunction, fuses and electrical connections should be checked for
condition and security.
In the event of a malfunction, the heater will shut down in its "fault lock-out" mode, no
visual indication will occur on the display of the timer.
Before consulting an authorised Webasto dealer, try to deactivate the fault lock-out
condition by switching the heater off (heater has to remain in the switched-off state for at
least 1 second) and then on again
.If this action does not correct the malfunction, consult your authorised Webasto dealer.

Summary

Troubleshooting

Maintenance and Safety Information

Installation and Certification

Follow installation instructions, keep approval certificate, and mark initial operation year.

Operation Hazards

Avoid operation in enclosed spaces, at filling stations, or where combustible vapours/dust form.

Inspection and Operation

Annual inspection required; stop operation for smoke, noise, or fuel smell, and use specified fuel.

Operational Limits and Liability

Adhere to temperature limits, cooling water requirements, and liability for installation/repairs.

Timer Operation

General Timer Functions

Preset start times up to 7 days in advance; adjust settings using specific buttons.

Heater Control

Switch heater on manually or automatically; switch off manually or after programmed time.

Time and Day Setting

Set the current time and day of the week using the clock and day buttons.

Programming Start Times

Program and recall up to three memory locations for heater operating start times.

Operating Time Programming

Set or adjust the heater's operating time, from 10 to 120 minutes.

Telestart T60 Operation

Remote Control Functionality

Remotely switch the heater on/off within 600m; operating time limited by receiver.

Transmitter Operation

Switch on via left button (LED flashes); switch off via right button.

Maintenance and Troubleshooting

Insert batteries, check battery contacts, and troubleshoot transmitter/receiver issues.

Webasto BBW 46 Specifications

General

Brand	Webasto
Model	BBW 46
Category	Water Heater
Language	English