Chiller Control:Start and stop of the chiller unit
•
Programming and setup of the chiller unit
•
Setup of directly connected air handlers
•
Selection of operation mode (Automatic, Cooling, Heating)
Cabin Control:
•
Start and stop of indirectly connected air handlers
•
Temperature and blower setting for indirectly connected air handlers
The operation mode can not be selected with the Cabin Control!
The digital control panel is always factory pre-programmed and the secondary commands are
code-protected.
•
If your chilled water system has a heating option, the cabins can be heated until the sea-
water temperature drops below 6 °C (43 °F).
The function „Automatic with Reverse Cycle” (F3) is pre-set.
•
If an external water heater is integrated in your chilled water system, you can heat inde-
pendently from the sea-water temperature (See separate heater documentation for further
details).
The function „Automatic with External Heater” (F4) is pre-set.
Cool cycle
mode
Automatic
mode
Heat cycle
mode
On / Off
Set-up / programming
Blower speed Lower values
Read-out
Higher
values
To Next Page
Loading...
Need help?
General
