To Next PageTo Next Page
Need help?Do you have a question about the Webasto BlueCool V50 M and is the answer not in the manual?
Details safety measures, including fire/explosion risks and switching off during refueling.
Guides on how to set the required cabin temperature using Plus/Minus controls.
Explains how to set fan speed manually or via automatic control.
Addresses initialisation or system blockages due to wiring issues.
Explains insufficient sea water flow, blocked strainer, or pump issues.
Addresses shutdown due to undervoltage for over 5 seconds.
Covers issues with low pressure compressor 1, possibly refrigerant shortage.
Details issues with high pressure compressor 1, sea water cooling, or cold water flow.
Covers low pressure compressor 2 issues, sea water flow, or strainer blockages.
Details high pressure compressor 2 issues, sea water cooling, or cold water flow.
Addresses defective cabin temperature sensor or wiring issues.
Covers defective cold water temperature sensor or wiring issues.
Explains insufficient cold water flow or blockages in the circuit.
Addresses high pressure compressor 1 issues in heating mode, like cold water pump defects.
Explains excess current due to undervoltage or overload.
Addresses high ambient temperature or insufficient cooling for the inverter.
Covers compressor 1 overheating due to insufficient sea water cooling.
Addresses defective high pressure sensor or wiring.
Addresses defective low pressure sensor or wiring.
Covers defective compressor temperature sensor or wiring.
Notes communication faults between inverter and pc-board.
Explains operation outside the characteristic diagram, e.g., due to cooling issues.
Addresses exceeding permissible temperature in the inverter housing.
Explains excess current due to load changes, short-circuits, or incorrect parameters.
General