CC8 roof-top air-conditioning system 4 Installation instructions
413
4.10 Install the roof-top unit with air ducting system or air distribution panel
4.10.1 Air duct sealing
A weatherseal is to be produced using the supplied sealing strips (see Fig. 407) for curved roofs or roofs with beads
and channels.
Fig. 406 Roof seal
The Armaflex/Eurobatex strip (32 x 25 x 850 mm) protecting the system against dirt must be bonded to the transverse
base frame profile of the roof-top unit with Sikaflex (supplied in the installation kit) so that the side with skin faces
outwards.
On flat roofs or roofs without beads and gutters a seal made with Sikaflex is sufficient instead of a weatherseal.
25
32
Roof-top air-conditioning system CC8
On a flat roof, with beads (Armaflex must
be cut out to match the bead pattern)
Roof-top air-conditioning system CC8
on a curved roof
Sealing sections
Sealing sections
NOTE
The dirt protection strip is not shown
in the front views.
NOTE
Spacers must be adapted to the roof contour as
required. Example of an adapted spacer.
Side with skin
To Next Page
Loading...
