Battery Replacement - Remote Control – V1
Remote controller battery requirements: Two AAA alkaline cells.
1. Slide the cell cover downward to take out the
worn cells. Replace the worn cells. (Note to the
correct polarity).
2. Close the cell cover.
3. The LCD will show all the functional figures and
letter codes after the batteries are installed. Wait
approximately 10 seconds for normal use.
4. The life span of batteries is approximately 1 year.
(Depending on usage)
5. If the remote controller doesn’t work after the
batteries have been replaced, remove the back
cover and press the “ACL” button to reset the
controller.
To Next Page
Loading...
