NOTE
If the signal cannot be transmitted correctly, the LED flashes (approx. 2
seconds) and then goes out.
u Repeat this procedure at a different location with better reception.
10.1
Switching on and off with the push button
ü The parking heater or parking ventilation mode is
displayed on the push button.
u
Press the push button (switch the heater or vent-
ilation on or off)
NOTE
When switching the unit on with the push button, the operating mode
(parking heater or parking ventilation) and the operating time, which
were last used with the hand-held transmitter, are always selected.
11
Changing the heating or ventilation
operating mode
u
Briefly press the ON and OFF push button 2x
within 1 second.
The operating indicator changes colour. During the
next time when the hand-held transmitter is oper-
ated, the heater operates in the selected operating
mode until the operating mode changes. See "Op-
erating mode indicator on page 5".
12
Switching off the heater
ü The operating indicator flashes (the heater is op-
erating).
u
Press the OFF push button until the operating in-
dicator lights up (approx. 1 sec.). Afterwards, the
operating indicator goes out. See also "Switching
on the heater on page 6"
| 9030719B | 7
To Next Page
Loading...
