Webb Electronics WebbPhone 150 Series - FCC Notice

WebbPhone 150 Manual 26 UG[WP-150] R9.6
FCC NOTICE
This device complies with Part 68 of the FCC rules. Our label contains the
FCC Registration Number, Ringer Equivalence Number (REN) and jack
description (USOC) for the device. If requested, this information must be
provided to the telephone company.
The REN is used to determine the quantity of devices which may be
connected to the telephone line. Excessive REN’s on the telephone line may
result in the devices not ringing in response to an incoming call. In most, but
not all areas, the sum of the REN’s should not exceed five (5.0). To be
certain of the number of devices that may be connected to the line, as
determined by the total REN’s, contact the telephone company to determine
the maximum REN for the calling area.
If this equipment causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of service
may be required. If advance notice isn’t practical, the telephone company
will notify the customer as soon as possible. Also, you will be advised of
your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment,
operations, or procedures that could affect the operation of the equipment. If
this happens, the telephone company will provide advance notice for you to
make the necessary modifications to maintain uninterrupted service.
If experiencing trouble with this equipment, please contact the Technical
Support Center at Webb Electronics Inc. for warranty and/or repair
information. If the trouble is causing harm to the telephone network, the
telephone company may request you to remove the equipment from the
network until the problem is resolved.
This equipment cannot be used on public coin service provided by the
telephone company. Connection to party lines is subject to state tariffs.
Contact your state public utilities commission for information.
This equipment does not provide data operation.
JACK (USOC): RJ11C
RINGER EQUIVALENCE = 0.8 Class B
Webb Phone Série 150 26 UG[WP-150]R9.6
Vous ne pouvez pas appeler et parler à l’aide d’un WebbPhone en
particulier.
 Vérifiez que ID de la cabine d’ascenseur a été programmé. Si un poste
de sauvetage LS-250 est connecté à l'unité, assurez-vous que la
fonction 13 du WebbPhone soit réglée sur « 1 ».
Questions liées à l’audio.
 Tourner le bouton SPKR dans le sens des aiguilles d’une montre
permettra de réduire le volume du haut-parleur. Tourner la commande
MIC dans le sens des aiguilles d’une montre permettra de réduire le
volume du microphone. Essayez cela en présence de microcoupures
audio.
 Pour MWP-150, assurez-vous qu'il est monté en mode flush dans le
panneau de commande de la cabine d’ascenseur - le WebbPhone ne
doit pas d’être écarté du panneau de commande de la cabine
d’ascenseur.
 Pour MWP-150, assurez-vous que le trou du microphone s’aligne avec le
trou prévu dans le panneau de commande de la cabine.