ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier.
Standard wrench sizes are listed.
Spark Plug Socket 16# x1
Spanner x1
Wrench 10-12# x1
Wrench 14-17# x1
Cable tie x1
When right or left hand is mentioned in this man
ual, it means when you are in the operating position
(seated be hind the steering wheel).
TO REMOVE TRACTOR FROM UNPACK
CRATE
• Remove all accessible loose parts and parts cartons
from crate.
• Cut along dotted lines on all four panels of crate.
• Remove end panels and lay side panels flat.
• Remove mower and packing materials.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
ATTACH STEERING HEEL (See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
• Slide extension shaft onto lower steering shaft.
• Place tabs of steering boot over tab slots in dash
and push down to secure.
INSTALL STEERING WHEEL
• Position front wheels of the tractor so they are
pointing straight forward.
• Remove steering wheel adapter from steering
wheel and slide adapter onto steering shaft
extension.
• Position steering wheel so cross bars are horizontal
(left to right) and slide inside boot and onto
adapter.
• Assemble large flat washer, 5/16 lock washer, 5/16
hex bolt and tighten securely.
• Snap steering wheel insert into center of steering
wheel.
• Remove protective materials from tractor hood and
grill.
IMPORTANT:
To Next Page
Loading...