SERVICE AND ADJUSTMENTS
• Depress brake pedal fully and set parking brake.
• Place attachment clutch in "DISENGAGED" position.
• Turn ignition key to "STOP" and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come
in contact with plug.
TO REMOVE MOWER (See Fig. 13)
• Place attachment clutch in "DISENGAGED" position.
• Lower attachment lift lever to its lowest position.
• Remove mower belt from electric clutch pulley (M).
• Disconnect front link (E) from mower - remove
retainer spring and washer.
• Go to either side of mower and disconnect mower
suspension arm (A) from chassis and rear lift link
(C) from
rear mower bracket (D) - remove retainer
springs and washers.
• Go to other side of mower and disconnect the
suspension arm and rear lift link.
• Slide mower out from under right side of tractor.
TO INSTALL MOWER (See Figs. 13-
17)
• Lower attachment lift lever to its lowest position.
NOTE:
• Slide mower under tractor until it is centered under
tractor.
.
To Next Page
Loading...