How to Assemble the Cutting Deck and Belt Cover
1. Position the cutting deck assby. X(fig.1.1) under the mower (see fig.1.2),and adjust the height stage to be the lowest.
Cutting Deck Assby.X
Fig.1.1 Fig.1.2
2. Assemble the height adjustment connecting bar D.
Step: position the cutting deck assby. to a suitable place, put two height adjustment connecting bars D into the eye bolts
C(fig.2.1), and insert the 8 type block pin B (fig.2.2).
Eye Bolt C Height Adjustment Connecting Bar D 8 Type Block Pin B
Fig.2.1 Fig.2.2
How to assemble 8 type block pin B：
(1). see fig.2.3, slightly insert the block pin tip into the pin hole;
(2). see fig.2.4, push the block pin through the pin hole.
(3). see fig.2.5, push the other head of block pin to let it close to the surface of height adjustment connecting bar.
Fig.2.3 Fig.2.4 Fig.2.5
To Next Page
Loading...