Webb WEH30 - Page 10

STEP 2 – FITTING THE GRASS COLLECTOR
1. To fit the grass collector to your lawnmower, posion the grass catcher onto the front
protecon cover.
STEP 3 – ADJUSTING THE CUTTING HEIGHT
The lawnmower can be set to any cung height, between 10mm & 40mm. Depending on the height
of the grass you are cung; you may want to adjust the cung height, using the four cung
heights available.
1. To adjust the cung height, pull out the two adjust knobs located on the outside of the side
plate.
2. Move the knobs up or d
own to locate into the suitable cung height hole.
INSTRUCTION MANUAL