Weber mt CF-2 HD - Fitting the Water Sprinkler System

14 CF-2
-Fasten the sprinkler tube (12/1) with the two screws
(12/2) at the front.
- Tighten the two screws (13/2) to fit the water tank
(13/1) to the protection frame.
- When the stop valve (13/3) is opened, water is
sprayed in front of the machine's base plate (12/1).
Caution!
Fill the water tank (14/1) up with clean water
only, because otherwise the water sprinkler
system (12/1) will get choked.
- Open the cap (14/2) to fill up the water tank.
Caution!
In case of danger of frost, completely drain
the water tank (14/1).
2.4.5 Fitting the Water Sprinkler System
Figure 12
Figure 13
Figure 14
2
1
1
2
1
2
3