Weber mt CR 7 - Compacting Procedure; Switching Off the Engine

22
ATTENTION
Danger of material damage or excessive wear if V-belt slips
through.
Operate the machine only in full-throttle mode, gas lever
position “ON”.
Start the engine.
Bring the gas lever into the full-throttle position “ON”.
Switch between forward and reverse travel by setting the
handle to the corresponding direction.
The forward and reverse travel of the machine is
innitelyvariable.
The speed of the machine is selected with the
correspondingdeectionofthehandle.
If the machine is equipped with the COMPATROL
compaction control system, the achieved compaction
of the soil can be read in the display.
The maximum possible compaction has been
reached when no additional LEDs come on after the
completion of another pass.
Switching o󰀨 the engine
Bring the gas lever into the idle speed position “STOP”.
Turn the ignition key to position "0".
If necessary, pull out the ignition key and close the
vandalismap.
CAUTION
Risk of injury if the machine is guided improperly.
Guide the machine safely with both hands on the handle.
CAUTION
There is a crushing hazard between the machine and the wall
during work in close proximity to walls.
Use extra caution when working close to obstacles.
ATTENTION
Risk of damage to the machine. Never work on soils that
cannot be compacted further. The optional COMPATROL 2.0
compaction control system warns of hard soils.
If all LEDs of the compaction indicator light up together with
the warning light, stop operation immediately.
Compacting