Weber CF 3 - Page 18

18 CF 3 L
Changing the oil in the exciter
Remove the oil drain/ller screw (1) and drain oil.
Fill with oil as specied in the ll quantity table.
Screw in the oil drain/ller screw.
Checking the V-belt
Remove the V-belt guard.
Check the V-belt (1) for cracks, damaged anks, and wear.
If there is excessive wear - replace the V-belt as specied in
the repair manual.
1
1
Clean/change air lter cartridge
Unscrew the air lter cover (1).
Remove the air lter insert (1) from the air lter enclosure
Clean the air lter insert in accordance with the
guidelines provided by the engine manufacturer, or
or extreme fouling replace.
1
1
1
Pull the fuel line (2) off the fuel lter (1) on both sides.
Replace the lter with a new lter element.
Change the fuel lter
2
Dispose of oils, greases, cloths soaked in oil, and
replaced parts with oil on them in an environmentally
friendly manner.
If lubricating oils and fuel come into contact with skin, they
can cause skin cancer. Upon contact with the skin, clean
affected skin with suitable cleaning agent without delay.
Dispose of oils, greases, cloths soaked in oil, and
replaced parts with oil on them in an environmentally
friendly manner.
Select a collection vessel that is large enough to pre-
vent oil from spilling on the ground. Dispose of waste
oil in an environmentally friendly manner (regulation on
waste oils).
Wipe up/off oil slick and oil residue and dispose of fuel-
soaked cleaning cloths in an environmentally responsible
manner.
1